Rotronic introduces a cleanroom panel for differential pressure

Published: 13-Jun-2016

The Rotronic CRP5 panel meets monitoring and control requirements for cleanroom environments

The Rotronic CRP5 panel meets monitoring and control requirements for cleanroom environments; with FDA 21CFR part 11 compliance and validated to GAMP5 Directives. It provides precise measurements of differential pressure using a diaphragm sensor, together with temperature and humidity.

The CRP5 has been designed for installation in cleanrooms in hospitals, pharmaceutical facilities, electronics production and assembly areas, food industry, laboratories and wherever small differences in pressure are critical.

The wall panel has a tough, wipe clean glass front plate which is highly resistant to chemicals; optical buttons can be operated using protective gloves. The option of a magnetically mounted humidity and temperature probe which is removable in seconds provides for efficient and effective cleaning.

Up to six measurement values can be shown on the graphical colour display. There are visual alarm indicators for defined values that have been breached, faults and alerts.

With its analogue and digital interfaces it is easy to integrate into any monitoring system; there are six relays. Configuration is easy using the four optical buttons and Rotronic HW4 software, or via Modbus RTU/TCP.

Any Rotronic HygroClip2 interchangeable temperature and humidity probe may be connected for measurement at a specific point in the cleanroom. Door monitoring is via contacts.

The operating ranges are wide: up to 500Pa, -100–200°C (probe dependent) and 0–100%rh.

The CRP5 panel sensors are easy to calibrate away from the cleanroom.

You may also like